非制冷微悬臂梁式红外焦平面探测器读出电路设计
DOI:
作者:
作者单位:

作者简介:

通讯作者:

中图分类号:

基金项目:

国家863高技术研究资助项目(2009AA04Z316)


Design of Readout Integrated Circuit for Uncooled Infrared Focal Plane Arrays Based on Microcantilever
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    针对非制冷微悬臂梁电容式红外探测器,设计了一款焦平面读出电路。根据电路噪声建模与分析,对电路进行了优化设计以抑制噪声。采用0.35μm 的CMOS工艺设计、制造了16×16读出电路原型,测试结果表明:5V电源电压、50Hz帧频下电路总功耗16.5mW,典型工作模式下线性度为99.2%,通道一致性大于97%,等效输入噪声电荷小于150e。

    Abstract:

    A Integrated readout circuit (ROIC)of focal plane arrays for uncooled infrared detector based on microcantilever was proposed. The ROIC was optimized to reduce noise based on noise modeling and analysis . A prototype of 16×16 ROIC was designed and fabricated by 0.35μm CMOS technology. The measurement results showe that the power dissipation is 16.5mW for a 5V supply voltage at 50Hz frame rate, the linearity is 99.2% at typical modes,the uniformity is larger than 97% and the equivalent noise charge (ENC) is below 150e.

    参考文献
    相似文献
    引证文献
引用本文

曹君敏,陈中建,鲁文高,张雅聪,雷科,赵宝瑛.非制冷微悬臂梁式红外焦平面探测器读出电路设计[J].红外与毫米波学报,2010,29(2):97~101]. CAO Jun-Min, CHEN Zhong-Jian, LU Wen-Gao, ZHANG Ya-Cong, LEI Ke, ZHAO Bao-Ying. Design of Readout Integrated Circuit for Uncooled Infrared Focal Plane Arrays Based on Microcantilever[J]. J. Infrared Millim. Waves,2010,29(2):97~101.]

复制
分享
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:2009-03-20
  • 最后修改日期:2009-09-30
  • 录用日期:2009-05-19
  • 在线发布日期: 2010-05-19
  • 出版日期:
文章二维码